Honda Fit: Changing the Front Wiper Blade Rubber
Honda Fit Owners Manual
1. Lift the driver side wiper arm first, then the passenger side.
2. Place a cloth on the edge of the lock tab.
Push the lock tab up with a flat-tip screwdriver.
3. Slide the blade from the wiper arm
NOTICE
Avoid dropping the wiper arm; it may damage the windshield.
4. Slide the wiper blade out from its holder by pulling the tabbed end out.
5. Remove the retainers from the rubber blade that has been removed, and mount to a new rubber blade.
► Correctly align the rubber protrusion and the retainer grooves.
6. Slide the new wiper blade onto the holder from the bottom end.
► The tab on the holder should fit in the indent of the wiper blade.
7. Slide the wiper blade onto the wiper arm, then push down the lock tab.
8. Lower the passenger side wiper arm first, then the driver side.
Other info:
Seat Ibiza. Jump-starting
Jump leads
The jump lead must have a sufficient wire cross section. If the engine fails
to start because of a discharged battery, the battery can be connected to the battery
of another vehicle to ...
Renault Clio. Maintenance and anti-pollution advice
Your vehicle complies with criteria for
recycling and recovering vehicles at the
end of their service life which will come
into force in 2015.
Some parts of your vehicle have therefore
been des ...
Seat Ibiza. Starting and stopping the engine
The engine can only be started using a genuine SEAT key with the correct code.
– Move the gear lever to the neutral position and depress the clutch pedal fully
and hold it in this position, the ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
