Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A).
The ignition must be switched to ACC or ON.
Type A
Type B
CAUTION
To prevent accessory socket damage or electrical failure, pay attention to the following:
Noise may occur on the audio playback depending on the device connected to the accessory socket
Depending on the device connected to the accessory socket, the vehicle's electrical system may be affected, which could cause the warning light to illuminate. Disconnect the connected device and make sure that the problem is resolved. If the problem is resolved, disconnect the device from the socket and switch the ignition off. If the problem is not resolved, consult an expert repairer, we recommend an Authorised Mazda Repairer.
NOTE
To prevent discharging of the battery, do not use the socket for long periods with the engine off or idling.
Nissan Micra. Air flow charts
The following charts show the button and dial
positions for MAXIMUM AND QUICK heating,
cooling or defrosting. The air intake lever
should always be in the position
for
heating and defrosting.
...
Honda Fit. TPMS (Tire Pressure Monitoring System)
U.S. models only
Monitors the tire pressure while you are
driving. If your vehicle’s tire pressure becomes
significantly low, the low tire pressure
indicator comes on.
Conditions such as low ...
Chevrolet Sonic. Dinghy Towing All except RS Model with Automatic Transmission
When dinghy towing a vehicle with an automatic transmission, the vehicle should
be run at the beginning of each day and at each RV fuel stop for about five minutes.
This will ensure proper lubrica ...