

The coolant level should be close to the "MAX" mark but should never exceed it.
When the engine is warm, the temperature of the coolant is regulated by the fan. This can operate with the ignition off.
For vehicles fitted with a particle emissions filter, the cooling fan may continue to run after stopping the vehicle, even if the engine is cold.
In addition, as the cooling system is pressurised, wait at least one hour after switching off the engine before carrying out any work. To avoid any risk of scalding, unscrew the cap by two turns to allow the pressure to drop. When the pressure has dropped, remove the cap and top up the level.
Changing the coolant
The coolant does not have to be changed.
Fluid specification
The coolant must conform to the manufacturer's recommendations.
Peugeot 208. Access to the tools
The tools are installed in the boot under the floor.
To gain access to them:
open the boot,
lift the floor and remove it.
remove the carrier box containing the tools.
List of tools
Al ...
Fiat Punto. To close the bonnet
Proceed as follows:
hold the bonnet up with one hand and, with the
other, remove rod (C) from recess (D) replace it in
its clip;
lower the bonnet at approx. 20 cm from the engine
compartme ...
Nissan Micra. Indicator lights
Automatic Transmission
position indicator light (A/T
models only)
When the ignition switch is in the ON position,
this indicator light shows the shift lever position.
For additional information ...